• Unplug the washer from the electrical outlet for 60 seconds, then plug it back in to perform a power reset• Verify the home circuit breaker for the washer is in the ON position and has not tripped• Check both the hot and cold water supply shut-off valves behind the washer are fully opened (turn counterclockwise)• Inspect both inlet hoses for visible kinks, twists, or pinching that could restrict water flow• Disconnect the inlet hoses from the back of the washer and inspect the screens inside the hose connections for debris or sediment; rinse screens with clean water if clogged• Verify the hot and cold water lines are connected to the correct inlet ports (hot to hot, cold to cold)• Ensure the washer is sitting level on the floor by checking with a level tool• Listen for water running and pressure at the connection points when fill cycle begins to confirm adequate water supply• Try running the washer with just the hot water supply connected (close cold valve) to test if one supply line is blocked• Check that you are using the correct detergent type (HE detergent for High Efficiency models if applicable)• Contact a qualified USA-based Amana service technician if error persists after these checks, as internal valve replacement may be required
