Home — Locations

Amana Washing Machine Error Code F1E2

This error code indicates a water temperature sensor malfunction or communication failure in your Amana washer. The F1 E2 error means the washing machine's control board cannot properly read or regulate water temperature, preventing the cycle from proceeding safely.

Common Symptoms

• Washing machine stops mid-cycle and displays F1 E2 on the control panel • Machine will not start a new wash cycle • Water does not heat to the selected temperature setting • Cycle appears to stall during the fill or wash phase • Control board beeps or displays error light repeatedly • Machine may drain water but refuses to continue the cycle

Possible Causes

• Faulty water temperature sensor (thermistor) located in the tub or inlet valve assembly • Loose or corroded wiring connections between the temperature sensor and control board • Mineral buildup or sediment from hard water blocking the temperature sensor probe • Defective inlet valve solenoid or temperature control valve unable to mix hot and cold water properly • Control board failure or corrupted software preventing sensor signal interpretation • Broken thermal fuse or damaged heating element wiring in 120V/60Hz USA models • Water inlet hose blockage reducing water flow to the temperature sensing area • Failed hot or cold water inlet valve preventing proper water mixing

Safety Checks You Can Do

• Unplug the washing machine from the 120V electrical outlet for 60 seconds, then plug it back in to reset the control board• Verify the home circuit breaker for the washer outlet is not tripped; switch it off and on if needed• Check that both the hot and cold water supply valves behind the washer are fully open (turn counterclockwise)• Inspect both inlet hoses (hot and cold) for kinks, twists, or visible damage that could restrict water flow• Look for debris or lint in the inlet hose screens by carefully disconnecting the hoses from the water valves• Ensure the washer is level on the floor using a spirit level; adjust the leveling feet if necessary• Confirm you are using the correct detergent type for your model (HE detergent for HE models only)• Check the drain hose for blockages or kinks that might cause the machine to sense incorrect water levels• Run a cleaning cycle with hot water and no clothes to help flush mineral deposits from the temperature sensor area• Verify the water supply is turned on at the main shut-off valve in your home

Amana Washing Machine Error Code F1E2

Common Symptoms

Possible Causes

Safety Checks You Can Do

Need More Help?