• Unplug the washing machine from the electrical outlet for 60 seconds, then plug it back in to perform a soft reset of the control board• Check your home's circuit breaker panel to ensure the breaker serving the washer has not tripped; reset if necessary• Verify both hot and cold water supply shut-off valves behind the washer are fully open• Inspect the inlet hoses (hot and cold water lines) for kinks, twists, or damage; straighten any bent sections• Disconnect the inlet hoses and visually inspect the small screens inside the hose connections for mineral buildup or debris; rinse screens under tap water if necessary• Check that the drain hose is not kinked or blocked and sits at the correct height (typically 30-96 inches above the floor)• Ensure the washer is sitting level on the floor using a spirit level; adjust the front leveling feet if needed• Review your detergent type to confirm you are using HE (high-efficiency) detergent if your Amana model requires it; switch to HE detergent and run a rinse cycle if you've been using regular detergent• Run a test cycle with no clothes to observe if the error reoccurs and at what point in the cycle• If you have extremely hard water, consider running a cleaning cycle with a commercial washing machine cleaner to dissolve mineral deposits in the sensor tube
