• Unplug the washing machine from the electrical outlet for 60 seconds, then plug it back in to perform a full system reset• Verify that your home circuit breaker supplying power to the washer has not tripped; reset if necessary• Check that both the hot and cold water supply valves located behind the washer are fully open and turned clockwise• Inspect both inlet hoses (hot and cold water) for kinks, cracks, or damage that could restrict water flow• Confirm that the inlet hoses are properly connected to both the washing machine and wall water supply connections• Verify the cold water inlet hose is connected to the cold water valve and the hot water inlet hose is connected to the hot water valve• Disconnect the inlet hoses and inspect the inlet screens (small mesh filters) for mineral buildup or debris; gently clean with a soft brush if needed• Ensure you are using the correct detergent type for your Amana model (HE detergent for HE washers; standard detergent for conventional models)• Check that the drain hose is not kinked, crushed, or clogged; ensure it is positioned at the correct height (typically 24-96 inches above the floor)• Verify the washing machine is level on the floor using a bubble level; adjust the front leveling feet if the machine is tilted• Run a test cycle with hot water selected to see if water heats properly; listen for the heating element to activate• If you have very hard water in your area, consider running a cleaning cycle using white vinegar to help dissolve mineral deposits• Document exactly when the error appears (immediately on startup, after a few minutes, at a specific cycle stage) to provide to a technician if professional service is needed
