Home Locations

Amana Oven Error Code F2 E0

This error code indicates a problem with the oven's temperature sensor (RTD probe) or its electrical connection. The oven cannot accurately read internal temperature, preventing normal cooking operation.

Common Symptoms

• Oven will not heat or maintain temperature • Error code F2 E0 displays on the control panel • Oven may shut off during cooking cycles • Control panel becomes unresponsive • Beeping sounds accompanied by the error message • Oven door may lock when error is active

Possible Causes

• Faulty or damaged temperature sensor (RTD probe) inside the oven cavity • Loose or corroded electrical connections to the temperature sensor • Damaged wiring harness between the sensor and control board • Control board malfunction preventing sensor signal recognition • Buildup of food debris or grease on the sensor tip affecting readings • Manufacturing defect in USA-model RTD probe (common in some Amana batches) • High voltage fluctuations from home electrical supply affecting sensor calibration

Safety Checks You Can Do

• Turn off power to the oven at your home's circuit breaker and wait 60 seconds, then turn back on to reset the appliance • Verify your home's circuit breaker for the oven is not tripped; reset if necessary • Ensure the oven door closes completely and latches properly • Check that no racks or items are blocking the oven door seal • Allow the oven to cool completely for at least 30 minutes before attempting to use it again • Look inside the oven cavity (safely, with power off) to see if there is obvious grease buildup on the temperature sensor probe located on the left or right interior wall • Verify all control panel buttons and settings are functioning normally • Check that the oven is not in self-cleaning mode, which may trigger sensor errors • If the error persists after these steps, the temperature sensor likely requires professional replacement

Need More Help?

Our support team is available 24/7 to assist you with any technical issues